1. Install technical measures
(1) its installation, commissioning, etc., should be in accordance with the parameters and drawings required. Before installation, to carry out the necessary checks, including anchor bolts, etc., there is the location of each component is correct and so on.
(2) the installation of the conveyor should be the base of the leveling, find, and then in accordance with the requirements of the order, pay attention to the base and anchor bolts should be tightened, can not appear loose and so on, otherwise there will be problems.
(3) reducer, motor installation, should be based on the drive wheel to make appropriate adjustments to meet the size requirements of various parts.
Its bracket should be coincident with the longitudinal center of the conveyor.
2. Safety measures for laying the belt
(1) before the laying of the belt, the first site to clean up, the channel to ensure smooth unimpeded Caixing.
(2) the middle of the roller, should be complete, the operation should be flexible.
(3) the tools used to lay the belt must be complete and complete.
(4) non-construction workers, can not carry out the construction site.
(5) the operation process should be in accordance with the provisions of the requirements, follow the command.
- Differentiation And Expression Of S...
- Reasons And Solutions Of Occurrence...
- What Are The Causes Of Damage To Th...
- The Use And Maintenance Of Screw Co...
- What Is The Condition Of The Screw ...
- Belt Conveyor
- LS Type Screw Conveyor Composition ...
- Operation Rules For Belt Conveyors
- Mobile Screw Conveyor
- Screw Conveyor Selection Points